diff options
Diffstat (limited to 'sys/dev/microcode')
| -rw-r--r-- | sys/dev/microcode/aic7xxx/aic79xx.reg | 4 | ||||
| -rw-r--r-- | sys/dev/microcode/aic7xxx/aic79xx.seq | 28 | ||||
| -rw-r--r-- | sys/dev/microcode/aic7xxx/aic7xxx.reg | 6 | ||||
| -rw-r--r-- | sys/dev/microcode/aic7xxx/aic7xxx.seq | 10 |
4 files changed, 24 insertions, 24 deletions
diff --git a/sys/dev/microcode/aic7xxx/aic79xx.reg b/sys/dev/microcode/aic7xxx/aic79xx.reg index 612cdb9b4c2..908d93979b6 100644 --- a/sys/dev/microcode/aic7xxx/aic79xx.reg +++ b/sys/dev/microcode/aic7xxx/aic79xx.reg @@ -1,4 +1,4 @@ -/* $NetBSD: aic79xx.reg,v 1.14 2019/05/28 08:59:34 msaitoh Exp $ */ +/* $NetBSD: aic79xx.reg,v 1.15 2022/01/25 22:01:34 andvar Exp $ */ /* * Aic79xx register and scratch ram definitions. @@ -2433,7 +2433,7 @@ register IOPDNCTL { } /* - * Shaddow Host Address. + * Shadow Host Address. */ register SHADDR { address 0x060 diff --git a/sys/dev/microcode/aic7xxx/aic79xx.seq b/sys/dev/microcode/aic7xxx/aic79xx.seq index 67478aa1812..2f2d4ce723d 100644 --- a/sys/dev/microcode/aic7xxx/aic79xx.seq +++ b/sys/dev/microcode/aic7xxx/aic79xx.seq @@ -1,4 +1,4 @@ -/* $NetBSD: aic79xx.seq,v 1.15 2021/09/19 10:34:09 andvar Exp $ */ +/* $NetBSD: aic79xx.seq,v 1.16 2022/01/25 22:01:34 andvar Exp $ */ /* * Adaptec U320 device driver firmware for Linux and FreeBSD. @@ -130,7 +130,7 @@ gsfifo_complete_normally: /* * Since this status did not consume a FIFO, we have to - * be a bit more dilligent in how we check for FIFOs pertaining + * be a bit more diligent in how we check for FIFOs pertaining * to this transaction. There are two states that a FIFO still * transferring data may be in. * @@ -362,7 +362,7 @@ END_CRITICAL; * Either post or fetch an SCB from host memory. The caller * is responsible for polling for transfer completion. * - * Prerequisits: Mode == M_CCHAN + * Prerequisites: Mode == M_CCHAN * SINDEX contains CCSCBCTL flags * SCBHADDR set to Host SCB address * SCBPTR set to SCB src location on "push" operations @@ -549,7 +549,7 @@ BEGIN_CRITICAL; test LQOSTAT1, LQOBUSFREE jnz idle_loop; /* - * On a phase change oustside of packet boundaries, + * On a phase change outside of packet boundaries, * LASTSCB points to the currently active SCB context * on the bus. */ @@ -754,7 +754,7 @@ p_status_okay: /* * Message out phase. If MSG_OUT is MSG_IDENTIFYFLAG, build a full - * indentify message sequence and send it to the target. The host may + * identify message sequence and send it to the target. The host may * override this behavior by setting the MK_MESSAGE bit in the SCB * control byte. This will cause us to interrupt the host and allow * it to handle the message phase completely on its own. If the bit @@ -764,9 +764,9 @@ p_status_okay: * * If MSG_OUT is == HOST_MSG, also interrupt the host and take a message. * This is done to allow the host to send messages outside of an identify - * sequence while protecting the seqencer from testing the MK_MESSAGE bit + * sequence while protecting the sequencer from testing the MK_MESSAGE bit * on an SCB that might not be for the current nexus. (For example, a - * BDR message in responce to a bad reselection would leave us pointed to + * BDR message in response to a bad reselection would leave us pointed to * an SCB that doesn't have anything to do with the current target). * * Otherwise, treat MSG_OUT as a 1 byte message to send (abort, abort tag, @@ -1080,7 +1080,7 @@ upload_scb: * Is it a disconnect message? Set a flag in the SCB to remind us * and await the bus going free. If this is an untagged transaction * store the SCB id for it in our untagged target table for lookup on - * a reselction. + * a reselection. */ mesgin_disconnect: /* @@ -1304,7 +1304,7 @@ idle_sg_avail: test DFSTATUS, PRELOAD_AVAIL jz return; /* * On the A, preloading a segment before HDMAENACK - * comes true can clobber the shaddow address of the + * comes true can clobber the shadow address of the * first segment in the S/G FIFO. Wait until it is * safe to proceed. */ @@ -1661,7 +1661,7 @@ main_isr: /* * There are two types of save pointers interrupts: * The first is a snapshot save pointers where the current FIFO is not - * active and contains a snapshot of the current poniter information. + * active and contains a snapshot of the current pointer information. * This happens between packets in a stream for a single L_Q. Since we * are not performing a pointer save, we can safely clear the channel * so it can be used for other transactions. On RTI capable controllers, @@ -1757,10 +1757,10 @@ pkt_handle_xfer: * Defer handling of this NONPACKREQ until we * can be sure it pertains to this FIFO. SAVEPTRS * will not be asserted if the NONPACKREQ is for us, - * so we must simulate it if shaddow is valid. If - * shaddow is not valid, keep running this FIFO until we + * so we must simulate it if shadow is valid. If + * shadow is not valid, keep running this FIFO until we * have satisfied the transfer by loading segments and - * waiting for either shaddow valid or last_seg_done. + * waiting for either shadow valid or last_seg_done. */ test MDFFSTAT, SHVALID jnz pkt_saveptrs; pkt_service_fifo: @@ -1894,7 +1894,7 @@ BEGIN_CRITICAL; END_CRITICAL; pkt_status_check_overrun: /* - * Status PKT overruns are uncerimoniously recovered with a + * Status PKT overruns are unceremoniously recovered with a * bus reset. If we've overrun, let the host know so that * recovery can be performed. * diff --git a/sys/dev/microcode/aic7xxx/aic7xxx.reg b/sys/dev/microcode/aic7xxx/aic7xxx.reg index b2f9e244f8e..8f252075840 100644 --- a/sys/dev/microcode/aic7xxx/aic7xxx.reg +++ b/sys/dev/microcode/aic7xxx/aic7xxx.reg @@ -39,7 +39,7 @@ * * $FreeBSD: /repoman/r/ncvs/src/sys/dev/aic7xxx/aic7xxx.reg,v 1.43 2003/01/20 20:44:55 gibbs Exp $ */ -VERSION = "$NetBSD: aic7xxx.reg,v 1.5 2021/08/07 19:41:14 andvar Exp $" +VERSION = "$NetBSD: aic7xxx.reg,v 1.6 2022/01/25 22:01:34 andvar Exp $" /* * This file is processed by the aic7xxx_asm utility for use in assembling @@ -329,7 +329,7 @@ register SSTAT2 { address 0x00d access_mode RO field OVERRUN 0x80 - field SHVALID 0x40 /* Shaddow Layer non-zero */ + field SHVALID 0x40 /* Shadow Layer non-zero */ field EXP_ACTIVE 0x10 /* SCSI Expander Active */ field CRCVALERR 0x08 /* CRC doesn't match (U3 only) */ field CRCENDERR 0x04 /* No terminal CRC packet (U3 only) */ @@ -949,7 +949,7 @@ register SCBCNT { /* * Queue In FIFO (p. 3-60) - * Input queue for queued SCBs (commands that the seqencer has yet to start) + * Input queue for queued SCBs (commands that the sequencer has yet to start) */ register QINFIFO { address 0x09b diff --git a/sys/dev/microcode/aic7xxx/aic7xxx.seq b/sys/dev/microcode/aic7xxx/aic7xxx.seq index 580976e777a..c51748c41fc 100644 --- a/sys/dev/microcode/aic7xxx/aic7xxx.seq +++ b/sys/dev/microcode/aic7xxx/aic7xxx.seq @@ -40,7 +40,7 @@ * $FreeBSD: /repoman/r/ncvs/src/sys/dev/aic7xxx/aic7xxx.seq,v 1.123 2003/01/20 20:44:55 gibbs Exp $ */ -VERSION = "$NetBSD: aic7xxx.seq,v 1.21 2021/09/03 22:33:17 andvar Exp $" +VERSION = "$NetBSD: aic7xxx.seq,v 1.22 2022/01/25 22:01:34 andvar Exp $" PATCH_ARG_LIST = "struct ahc_softc *ahc" PREFIX = "ahc_" @@ -1476,7 +1476,7 @@ p_status_okay: /* * Message out phase. If MSG_OUT is MSG_IDENTIFYFLAG, build a full - * indentify message sequence and send it to the target. The host may + * identify message sequence and send it to the target. The host may * override this behavior by setting the MK_MESSAGE bit in the SCB * control byte. This will cause us to interrupt the host and allow * it to handle the message phase completely on its own. If the bit @@ -1486,9 +1486,9 @@ p_status_okay: * * If MSG_OUT is == HOST_MSG, also interrupt the host and take a message. * This is done to allow the host to send messages outside of an identify - * sequence while protecting the seqencer from testing the MK_MESSAGE bit + * sequence while protecting the sequencer from testing the MK_MESSAGE bit * on an SCB that might not be for the current nexus. (For example, a - * BDR message in responce to a bad reselection would leave us pointed to + * BDR message in response to a bad reselection would leave us pointed to * an SCB that doesn't have anything to do with the current target). * * Otherwise, treat MSG_OUT as a 1 byte message to send (abort, abort tag, @@ -1696,7 +1696,7 @@ if ((ahc->flags & AHC_INITIATORROLE) != 0) { * Is it a disconnect message? Set a flag in the SCB to remind us * and await the bus going free. If this is an untagged transaction * store the SCB id for it in our untagged target table for lookup on - * a reselction. + * a reselection. */ mesgin_disconnect: /* |
